local::lib bootstrap
The local::lib module is an essential piece of my workflow nowadays. It allows me to easily keep each project Perl modules separate, and therefore minimize breakage.
Bootstrapping local::lib was reasonably simple but it got a lot simpler with the latest 1.004001 version. Basically you can just pipe the output of a URL into perl to bootstrap it.
The URL is some long beast in the cpansearch.perl.org site, impossible for me to memorize, so I created a shorter version, http:://bit.ly/local-lib. To bootstrap local::lib you now can:
wget -O- http://bit.ly/local-lib | TARGET=target_dir perl
or if you are a curl user:
curl -L http://bit.ly/local-lib | TARGET=target_dir perl
I wish I didn't have to specify the TARGET environment. It should assume, like the previous bootstrap process, ~/perl5. I'll whip up a patch tomorrow.
There is no permalink to the latest version of the bootstrap script, so until I can find a way to alter the destination URL, we are stuck with the current version of it. I do hope a more definitive URL shows up, like the suggested http://install.local-lib.pl/.
The process worked fine for me in a couple of servers around here, but it is not a complete bootstrap. This process installs the local::lib module but doesn't adjust your shell configuration to make the settings stick.
So after you need to run this:
TARGET=perl6 echo "eval \$(perl -I$TARGET/lib/perl5 \
-Mlocal::lib)" >>~/.bashrc
(see the local::lib bootstraping section for csh instructions)
Its an excellent service, and it can only get better.
